How do you hook up a lionel transformer

how do you hook up a lionel transformer

How do you wire a Lionel ZW transformer?

Proper wiring for the ZW transformer is a bit of a safety issue. The Lionel ZW has four sets of posts and six controls. First things first: The two big throttles correspond with the A-U and D-U posts. The U posts go to the outer rails of your track. The A or B post go to the center rail. Each throttle controls its own loop of track.

How many posts does a Lionel ZW have?

The Lionel ZW has four sets of posts and six controls. First things first: The two big throttles correspond with the A-U and D-U posts. The U posts go to the outer rails of your track. The A or B post go to the center rail. Each throttle controls its own loop of track.

What happens if you derail a train with a ZW transformer?

If you derail a train 12 amps of power can run through the wire for 10-15 seconds before the circuit breaker kicks in. You don’t want the insulation to melt and catch fire. Proper wiring for the ZW transformer is a bit of a safety issue. The Lionel ZW has four sets of posts and six controls.

How do you hook up electricity to a track?

The electricity will take the shortest route. Then, at every point where you need feeder wires to your track, drill holes in the table, run wires up to the track, and splice those wires into the loop. I like to just cut the wire, strip back a bit of insulation, then twist all three wires together and secure them with a wire nut.

How do you replace a Lionel ZW circuit breaker?

You may need to lengthen one or both of the wires in order for it to reach. Once you have the replacement Lionel ZW circuit breaker in place, replace the cover and the four screws. Plug in the transformer, turn up one of the throttles, and short out its terminals. The circuit breaker should activate in about three seconds.

What does a Lionel ZW transformer look like?

The Lionel ZW has four sets of variable outputs, four throttles, two whistle/direction controls, a power light, and a short circuit light. The ZW is just like any other transformer in that you need to check it for safety before you use it.

How does a Lionel tubular track connect to a transformer?

Traditional Lionel tubular track connects to the transformer with a lockon, a small fiber board with contacts that clip onto a track, and two wire terminals. The lockon connects to your center rail and one of your outer rails.

What happens if you derail a train with a ZW transformer?

If you derail a train 12 amps of power can run through the wire for 10-15 seconds before the circuit breaker kicks in. You don’t want the insulation to melt and catch fire. Proper wiring for the ZW transformer is a bit of a safety issue. The Lionel ZW has four sets of posts and six controls.

Related posts: